标题: 刀路计算完成出现这样一串警告，咋办？ [打印本页] 作者: dasha 时间: 2005-5-14 10:51 标题: 刀路计算完成出现这样一串警告，咋办？ * A region at coordinates X-64.749 Y-32.523 Z-41.000 is too small to mill with 'Corner Milling - All Round'
Either reduce the 'Min. Radius' or use 'External Round'.
* A region at coordinates X-64.749 Y-32.523 Z-41.000 was NOT milled.
In order to prevent cutter breakage, all regions below were not calculated.
* AT X = -59.056, Y = 35.478, Z = -41.000 CONTOUR FOR MILLING OR FOR RAMP ANGLE IS SMALLER THAN PLUNGE SIZE.
NO MILLING WILL TAKE PLACE IN THIS LAYER!!!
* AT X = 59.347, Y = 35.167, Z = -41.000 CONTOUR FOR MILLING OR FOR RAMP ANGLE IS SMALLER THAN PLUNGE SIZE.
NO MILLING WILL TAKE PLACE IN THIS LAYER!!!
* A region at coordinates X64.749 Y-32.696 Z-41.000 is too small to mill with 'Corner Milling - All Round'
Either reduce the 'Min. Radius' or use 'External Round'.
* A region at coordinates X64.749 Y-32.696 Z-41.000 was NOT milled.
In order to prevent cutter breakage, all regions below were not calculated.
* PROCEDURE EXECUTION END TIME : 14/05/2005.09:31:00
*
* PROCEDURE VOLUME MILLING-SPIRAL CUT - 3D = 3 IS REPLACED
* 作者: zhenglianmm 时间: 2005-5-14 20:03
* A region at coordinates X-64.749 Y-32.523 Z-41.000 is too small to mill with 'Corner Milling - All Round' 用lling - All Round'方式铣削过不去
Either reduce the 'Min. Radius' or use 'External Round'. 输入最小半径，或用外部圆角的方式
* A region at coordinates X-64.749 Y-32.523 Z-41.000 was NOT milled.
In order to prevent cutter breakage, all regions below were not calculated. X-64.749 Y-32.523 Z-41.000 没有铣削到
为了防止段刀，以下的区域都没有计算
* AT X = -59.056, Y = 35.478, Z = -41.000 CONTOUR FOR MILLING OR FOR RAMP ANGLE IS SMALLER THAN PLUNGE SIZE.
X = -59.056, Y = 35.478, Z = -41.000这个点的铣削角度小于插入尺寸
NO MILLING WILL TAKE PLACE IN THIS LAYER!!!
这一层将没有铣削
*
*没时间了，就是你的程序有些地方出错了，照着提示检查一下 作者: dasha 时间: 2005-5-15 08:45
在it里面做就没有这样的警告，到底怎么回事呀？作者: dasha 时间: 2005-5-16 17:45
不懂为什么？怎样才能避免呢？