1. Operation Manager ---> Create New Setup Section
2. Copy or Move all the Tool Path into the New Setup Section
3. There is a Icon "Merge", merge the New Setup section.作者: sinderal 时间: 2002-12-29 21:24
There are Half Ball but cut by the Cyliner Surface.
You could "Edit" --> Surface --> Untrim and your could find the Surface.作者: sinderal 时间: 2003-1-1 00:22
多多運用Surfcam裡的曲面技巧...
偶很多四五軸的東西都是這樣做出來的....作者: zzhzzhzzh 时间: 2003-3-11 00:24
下图为 1)5.5mm钻头钻孔,孔深2.45mm
2) 3mm球刀4axis cut加工
3)模拟仿真图
有两个问题请教:
1)钻孔时选点我是用先创曲面复线(Surface Spline),然后求交点来确定点,你们用什么办法?
2)若用6mm球刀钻孔,采用钻孔NC> 4axis >Drill 怎 样调用出球刀?作者: sinderal 时间: 2003-3-11 08:29
1. 钻孔
There are Half Ball but cut by the Cyliner Surface.
You could "Edit" --> Surface --> Untrim and your could find the Surface.
Create --> Surface Spline --> Edge
Create --> Arc --> From Spline
Create --> Point --> Center
2. 6mm球刀钻孔
看加工到多深, 用選鑽頭, 包含刀尖角深度, 真正加工時用球刀.. 另外, 用2 Axis Drill就可以, 一次做一排, 再用 Transform --> Indexd Array 作者: zzhzzhzzh 时间: 2003-3-11 12:47
I Get it! Thanks a lot!