iCAx开思网

标题: 能不能帮我改9.1sp2后处理,谢谢! [打印本页]

作者: donghuei 时间: 2006-4-29 11:52
标题: 能不能帮我改9.1sp2后处理,谢谢!
改9.1sp2后处理改成下面一样的.特别是一开头不要出现"m6"到下面刀径不一样的时候出现"m6"就可以了.这样的好处就是不小心把刀名输一样换刀的时候会机床会报警.如果不出现"m6"机床不会报警直接做下去东西就报废了.谢谢高手有的话给我一个.或者教我怎样改.我的mall:donghuei2005@21cn.com 我已经改了三天了还是不行.下载了很多都不行.

%
N100G0G17G40G49G80G90
(UNDEFINED TOOL - 1 DIA. OFF. - 1 LEN. - 1 DIA 35. R 5.)
N102G0G90G54X40.952Y-48.222S1500M3
N104G43H1Z80.M8
N106Z5.
N108G1Z0.F500.
N110G3X44.952Y-44.222R4.F1000.
N112X40.952Y-40.222R4.
N114G1X-60.503
N116G2X-78.003Y-22.722R17.5
N118G1Y40.16
N120G2X-60.503Y57.66R17.5
N122G1X40.952
N124G2X58.452Y40.16R17.5
N126G1Y-22.722
N128G2X40.952Y-40.222R17.5
N130G3X36.952Y-44.222R4.
N132X40.952Y-48.222R4.
N134G0Z80.
N136M5
N138M9
N140M01
(TOOL - 2 DIA. OFF. - 2 LEN. - 2 DIA 16. R .8)
N142T2M6
N144G0G90G54X40.952Y-34.379A0.S2000M3
N146G43H2Z80.M8
N148Z5.
N150G1Z0.F300.
N152G3X42.78Y-32.55R1.828F1200.
N154X40.952Y-30.722R1.828
N156G1X-60.503
N158G2X-68.503Y-22.722R8.
N160G1Y40.16
N162G2X-60.503Y48.16R8.
N164G1X40.952
N166G2X48.952Y40.16R8.
N168G1Y-22.722
N170G2X40.952Y-30.722R8.
N172G3X39.123Y-32.55R1.829
N174X40.952Y-34.379R1.829
N176G0Z80.
N178M5
N180M9
N182M30
%

作者: donghuei 时间: 2006-4-29 22:29
自己顶!

作者: donghuei 时间: 2006-5-2 09:08
我再顶!

欢迎光临 iCAx开思网 (https://www.icax.org/)