iCAx开思网

标题: 为什么会干涉? [打印本页]

作者: mjhyj 时间: 2006-9-6 17:12
标题: 为什么会干涉?
原为0.3mm一刀,因附件要小于512MB,改为1mm一刀,尽示意.
Collision/gouge check summary

Note: Only the tool is checked for collisions and gouges.
   The tool holder is not checked.

Number of operations analyzed:  1
Number of reported collisions:  0
Total reported collision volume:  0.00000
Total collision volume:  0.00000
Number of reported gouges:  11
Total reported gouge volume:  11.94033
Total gouge volume:  80.66720

Gouge/collision points with a volume of at least 0.12629

Gouge:    X441.576 Y134.773 Z-21.158 Volume = 0.88991 Depth = 0.026 Tool #6 ID #12
Gouge:    X456.744 Y559.846 Z-21.158 Volume = 1.01297 Depth = 0.033 Tool #6 ID #12
Gouge:    X160.750 Y575.217 Z-21.158 Volume = 0.83256 Depth = 0.026 Tool #6 ID #12
Gouge:    X456.280 Y559.514 Z-22.157 Volume = 1.94391 Depth = 0.040 Tool #6 ID #12
Gouge:    X161.880 Y574.767 Z-22.157 Volume = 1.37722 Depth = 0.026 Tool #6 ID #12
Gouge:    X455.934 Y559.191 Z-23.155 Volume = 0.22333 Depth = 0.033 Tool #6 ID #12
Gouge:    X195.181 Y311.413 Z-109.983 Volume = 0.94765 Depth = 0.073 Tool #6 ID #12
Gouge:    X436.465 Y139.014 Z-110.981 Volume = 0.38893 Depth = 0.033 Tool #6 ID #12
Gouge:    X195.402 Y310.987 Z-110.981 Volume = 0.17434 Depth = 0.026 Tool #6 ID #12
Gouge:    X205.728 Y570.953 Z-111.979 Volume = 2.36664 Depth = 0.073 Tool #6 ID #12
Gouge:    X452.215 Y555.297 Z-113.975 Volume = 1.78286 Depth = 0.033 Tool #6 ID #12

作者: mjhyj 时间: 2006-9-6 17:23
标题: MC8文件
不好意思,附件太大,又改为2MM一刀
MC8文件见附件

作者: y6618417 时间: 2007-4-8 23:15
没怎么看懂你想问的意思..

作者: pogua007 时间: 2007-4-8 23:32
我知道了，他把K说成M了，然后其他意思我还不知道

欢迎光临 iCAx开思网 (https://www.icax.org/)