标题: Split program without nc software? [打印本页] 作者: RAY 时间: 2002-4-27 05:42 标题: Split program without nc software? What software do you use to make setup sheet and split programs?
I used NC_Doc in Cimatron, It is slow and sucks.
Now I am using Microsoft word Marcos still not very friendly.作者: zhaona_1 时间: 2002-4-27 10:39
在mastercam中有专门的功能来做setup sheet,split programe用她自带的程序.作者: RAY 时间: 2002-4-27 20:31
I have 20 machines in the shop , some has no tool changer ,operators need to split programs for those machines , I have only four licensed Cimatron and two
MasterCams. Is is too expensive to install nc software for all machines plus not all operaters know how to use them.Now I use MS word they can simply click on the Gcode program to make they own tool list and split the programs for diffent controls.作者: sinderal 时间: 2002-4-27 21:08
1. You could use some DNC system Like Multi-DNC system at the shopfloor, like Multi-DNc /2 or /4 -----
2. You also could addon Multi-View on the Multi-DNC, so your operators could view all the NC Program, Part Drawing, Execl file, Word file, Tool List ... in one JOB Folder.
3. You also could add Miachine Monitoring System, to management your Shopfloor.