iCAx开思网

标题: 李军的小车模型在matlab和adams 联合仿真中的问题 [打印本页]

作者: ipyuren 时间: 2008-8-21 17:11
标题: 李军的小车模型在matlab和adams 联合仿真中的问题
我们采用matlab的simulink与adams联合仿真，在联合仿真中，如果后轮驱动采用motion驱动是有问题的，程序报错，总是说一些joint不存在，一些motion不存在。看似联合仿真过程中，模型中的'JOINT_30'和'JOINT_29'以及他们上面附加的运动没有被引入。

Error detected on line number 2279, character 33 of ls723.cmd.
ERROR: No Joint was found because 'JOINT_30' does not exist beneath '.jeep'.
ERROR: The command was not executed.
ERROR: &> joint_name = .jeep.JOINT_30  &
ERROR: ---------------------------------------------------------------------
ERROR: ---------------------------------------------------------------------
ERROR: Error detected on line number 2283, character 38 of ls723.cmd.
ERROR: No Constraint was found because 'MOTION_4' does not exist beneath '.jeep'.
ERROR: The command was not executed.
ERROR: &> constraint_name = .jeep.MOTION_4  &
ERROR: ---------------------------------------------------------------------
ERROR: ---------------------------------------------------------------------
ERROR: Error detected on line number 2290, character 33 of ls723.cmd.
ERROR: No Joint was found because 'JOINT_29' does not exist beneath '.jeep'.
ERROR: The command was not executed.
ERROR: &> joint_name = .jeep.JOINT_29  &
ERROR: ---------------------------------------------------------------------
ERROR: ---------------------------------------------------------------------
ERROR: Error detected on line number 2294, character 38 of ls723.cmd.
ERROR: No Constraint was found because 'MOTION_5' does not exist beneath '.jeep'.
ERROR: The command was not executed.
ERROR: &> constraint_name = .jeep.MOTION_5  &
ERROR: ---------------------------------------------------------------------
ERROR: ---------------------------------------------------------------------
ERROR: Error detected on line number 3128, character 34 of ls723.cmd.
ERROR: No Motion was found because 'MOTION_4' does not exist beneath '.jeep'.
ERROR: The command was not executed.
ERROR: &> motion_name = .jeep.MOTION_4  &
ERROR: ---------------------------------------------------------------------
ERROR: ---------------------------------------------------------------------
ERROR: Error detected on line number 3132, character 34 of ls723.cmd.
ERROR: No Motion was found because 'MOTION_5' does not exist beneath '.jeep'.
ERROR: The command was not executed.
ERROR: &> motion_name = .jeep.MOTION_5  &
ERROR: ---------------------------------------------------------------------

但是同样的模型，如果采用Force驱动后轮进行联合仿真则没有问题。不知这是什么原因。

另外说明一下，这个模型在admas里面单独运行，前后轮都用motion驱动，没有问题

还有就是ADAMS单独运行没有问题，但是和matlab链接就是出现轮子解体的问题，不知为什么？

欢迎光临 iCAx开思网 (https://www.icax.org/)