iCAx开思网

标题: 关于4轴旋转角度极限定义!! [打印本页]

作者: 深圳小优 时间: 2009-3-3 17:28
标题: 关于4轴旋转角度极限定义!!
现在用PM编程序
使用的是旋转精加工..可是后处理不配套
对PM的后处理修改不是很熟悉!!
现在一切都已经OK
但是C轴现在是累计旋转的就是旋转到8万多度``
想修改一下极限形成,就是到359.999度自动更改从0开始计算
关于4轴旋转角度极限定义不知道怎么定义

如果有懂的朋友请帮忙`谢谢!!!!!!!!!1

作者: cystall 时间: 2009-3-5 16:22
This will allow the rotary elevation axis to maintain constant direction of rotation +/- when the usual maximum limit of 30000 degrees rotation is reached. That is, the post option will change the angles of 29880; 29881; 29882 to be output as 29880; 1 M94 C ; 2; 3; etc.
( 29880 / 360 = 83 full revolutions - the limiting value must always be exactly divisible by 360 )

At the machine control interface carry out the following :-
1, Go into Program and Edit mode.
2, Press the MOD KEY
3, Enter 95148 (password)
4, Go To MP 810.3
5, This will probably be set to 0 (This is incorrect to run M94 Reducing angle)
6, Change to 360 ( Max angle of 360 )
7, Enter End
8, Exit Edit mode back to Manual
9, Soft Key Pass Over Ref. M94 only on Rotary Elevation axis should be necessary

作者: cystall 时间: 2009-5-6 16:15
上面内容是我误解了你的意思发的不好意思！你把后置给我我帮你修改下！

作者: ysr_01 时间: 2009-5-6 20:12
二楼的

这资料也被你搞到了。。。。，应该我认得你。。。

本帖最后由 ysr_01 于 2009-5-6 20:14 编辑

欢迎光临 iCAx开思网 (https://www.icax.org/)