标题: 一般混合 [打印本页] 作者: 合叶126 时间: 2009-4-8 11:01 标题: 一般混合 我是pro/e得初学者
使用一般混合绘图后，总出现：
Not all elements are defined. Select element(s) or action(s) from dialog box.
不知道问题出在哪儿？
大家能否帮忙解答一下。作者: wangxbjing 时间: 2009-4-8 11:50
把的你画法贴图上来吧。作者: 合叶126 时间: 2009-4-8 16:40
画法？
Arrow shows direction of feature creation. Pick FLIP or OKAY.
Select or create a horizontal or vertical reference for sketching.
Select a perpendicular surface, an edge, or vertex relative to which the section will be dimensioned and constrained.
Select a perpendicular surface, an edge, or vertex relative to which the section will be dimensioned and constrained.
Select start point.
When constraint is displayed: Right click to disable it. Press Shift + right click to lock it. Use Tab key to toggle active constraint.
Select end point.
When constraint is displayed: Right click to disable it. Press Shift + right click to lock it. Use Tab key to toggle active constraint.
Select start point.
When constraint is displayed: Right click to disable it. Press Shift + right click to lock it. Use Tab key to toggle active constraint.
Coordinate system is missing.
Enter x_axis rotating angle for section 2 (Range:+-120) 0.00
Enter y_axis rotating angle for section 2 (Range:+-120) 20
Enter z_axis rotating angle for section 2 (Range:+-120) 0.00
Continue to next section? (Y/N): Yes
Enter x_axis rotating angle for section 3 (Range:+-120) 0.00
Enter y_axis rotating angle for section 3 (Range:+-120) 10
Enter z_axis rotating angle for section 3 (Range:+-120) 0.00
Continue to next section? (Y/N): No
Not all elements are defined. Select element(s) or action(s) from dialog box.
