标题: 【讨论】SPline Curvature Rate Control [打印本页] 作者: ccf 时间: 2002-9-8 09:52 标题: 【讨论】SPline Curvature Rate Control Hi all,
1) how to control the curvature rate of a spline in ProE numerically ?
2) How to get a best smooth curve or ensure the curve having the curvature i want ? Not only by visual.
Many thanks for any idea.作者: ccf 时间: 2002-9-8 09:54
2作者: ccf 时间: 2002-9-8 09:57
3作者: ccf 时间: 2002-9-8 09:59
section , example作者: ccf 时间: 2002-9-8 22:07
Hmmm...i think this cannot be done in ProE, last time i was told by a PTC agent say it can be done, cheated i guess . 作者: emric 时间: 2002-9-8 23:38
你的英文水平挺不错的啊!!呵呵,我不知道耶!!作者: ccf 时间: 2002-9-9 01:10
I wish to type in Chinese, wait untill i get my Chinese Star . 作者: 破衣人 时间: 2002-9-9 11:15
I know what you mean.
But I didn't find any solution till now.
The way that I do is adjusting the curvature number at the end ( in ISDX )
And let them look similarly,not accurately.
.作者: ____ 时间: 2002-9-9 16:43
我用bmx做了一个研究，基本上可以达到你的要求，不过有点繁：
1）建立一个曲率的测量分析，增加两个参数:MAX_CURV(最大曲率），MIN_CURV(最小曲率）。
2)建立一个关系：delta=MAX_CURV:FID_ANALYSIS1-MIN_CURV:FID_ANALYSIS1
3以MAX_CURV=某直（你想要的），DELTA为最小为目的，spiline的插入点坐标为变量进行最优化分析得到结果
敏感度分析有点繁，点越多越不好控制。
贴上一个草图(狠草的图）作者: ccf 时间: 2002-9-9 23:48
great idea thanks . I will try ask in other newsgroup and feed back ASAP.作者: sixer 时间: 2002-9-10 12:01
then wait for ur feedback
