请教:如何处理MSC/Nastran提示

georgejoy · 发表于 2005-12-9 11:14:34

马上注册，结交更多同行朋友，交流，分享，学习。

您需要登录才可以下载或查看，没有帐号？注册

x

以MSC/Nastran(2005R2)作UGNX3.0求解器,求解一个零件后, 不能进入Post Processing,
点Analysis Job Information按钮时提示文件如下:
------------------------------------------------------------

Reading Nastran list file. Check file for further details:
F:\AB\mscmy-msc.f06

------------------------------------------------------------

Nastran Msg: *** USER FATAL MESSAGE 601 (IFP1D)
   THE KEYWORD ON THE ABOVE CARD TYPE IS ILLEGAL OR MISSPELLED.
               15    SPCFORCES(PLOT) = ALL
               16    SPC = 1
               17    $
               18    SUBCASE 1
               19    SUBTITLE=SUBCASE - STATIC LOADS 1
               20    LOAD = 1
               21    $
               22    $
               23    $ ---------------- END CASE CONTROL ---------------------------
               24    $ --------------- BEGIN BULK DATA ---------------------------
               25    $
               26    BEGIN BULK
Nastran Msg: ^^^ USER FATAL MESSAGE 9002 (IFPL)
^^^ ERROR ENCOUNTERED IN THE CASE CONTROL SECTION

Total messages:  WARNING 0 , FATAL 2
------------------------------------------------------------
请该如何处理?