Split program without nc software?

只看该作者 · 发表于 2002-4-27 05:42:27

马上注册，结交更多同行朋友，交流，分享，学习。

您需要登录才可以下载或查看，没有帐号？注册

x

What software do you use to make setup sheet and split programs?
I used NC_Doc in Cimatron, It is slow and sucks.
Now I am using Microsoft word Marcos still not very friendly.

只看该作者 · 发表于 2002-4-27 10:39:45

在mastercam中有专门的功能来做setup sheet,split programe用她自带的程序.

只看该作者 · 发表于 2002-4-27 20:31:29

I have 20 machines in the shop , some has no tool changer ,operators need to split programs for those machines , I have only four licensed Cimatron and two
MasterCams. Is is too expensive to install nc software for all machines plus not all operaters know how to use them.Now I use MS word they can simply click on the Gcode program to make they own tool list and split the programs for diffent controls.

只看该作者 · 发表于 2002-4-27 21:08:09

1. You could use some DNC system Like Multi-DNC system at the shopfloor, like Multi-DNc /2 or /4 -----
2. You also could addon Multi-View on the Multi-DNC, so your operators could view all the NC Program, Part Drawing, Execl file, Word file, Tool List ... in one JOB Folder.
3. You also could add Miachine Monitoring System, to management your Shopfloor.

https://www.multi-dnc.com/indexmulti.html

Hope above information could help you!

只看该作者 · 发表于 2014-2-23 21:40:51

So this is the first post 12 years ago Ray posted in this forum?