体积块的配置只加工方法与XZ平面圆弧后处理请教

tangyi3000

请教两个问题
1."体积块"的"配置只"加工方式能不能反转切削方向?在参数里把"切割方向"由"标准"改为"反转"也不行
2.我用"轨迹"走一条在XZ平面上有圆弧和斜度的线,后处理出来在圆弧位上都会变形.圆弧才8.0MM.后面只好输出为点位先应付加工.另外可不可以设置仅XZ与YZ平面上的圆弧出为点位,XY还是用插补呢?
以下是程式
%
N1 (Date:09/27/09 Time:18:13:52)
N2 ( / PART NAME : YZB01)
N3 ( / SEQUENCE TYPE : TRAJECTORY MILLING)
N4 ( / TOOL_TYPE : BALL MILL)
N5 ( / CUTTER DIAMETER, 1.500)
N6 ( / LENGTH : 50.000000)
N7 G17 G40 G54 G49 G80
N8 G91 G28 Z0
N9 S3000 M03
N10 G0 G90 X-100.675 Y-58.98
N11 Z20.
N12 Z.037
N13 G1 Z-1.963 F400.
N14 X-93.09 Z-7.107
N15 G18
N16 G3 X-85.557 Z-9.42 I7.533 K11.108
N17 G1 X85.557
N18 G3 X93.09 Z-7.107 I0. K13.421
N19 G1 X100.675 Z-1.963
N20 X99.279 Z-2.91
N21 Z2.5 F5000.
N22 G0 X-100.675
N23 G1 Z-.023 F2540.
N24 Z-2.023 F400.
N25 X-93.09 Z-7.167
N26 G3 X-85.557 Z-9.48 I7.533 K11.108
N27 G1 X85.557
N28 G3 X93.09 Z-7.167 I0. K13.421
N29 G1 X100.675 Z-2.023
N30 X99.279 Z-2.97
N31 Z2.5 F5000.
N32 G0 X-100.675
N33 Z-.083
N34 G1 Z-2.083 F400.
N35 X-93.09 Z-7.227
N36 G3 X-85.557 Z-9.54 I7.533 K11.108
N37 G1 X85.557
N38 G3 X93.09 Z-7.227 I0. K13.421
N39 G1 X100.675 Z-2.083
N40 X99.279 Z-3.03
N41 Z2.5 F5000.
N42 G0 X-100.675

WRF972140