希望可以 启动 后 自动执行 UG 的宏 或者 grip 程序，然后 自动退出 UG！作者: anthony2008 时间: 2005-2-22 10:45
修改UGII\menus\custom_dirs.dat 文件,指定你的startup目录就可以了,试试吧.作者: Yeager 时间: 2005-2-22 11:38
剛好有兩種方式:
1.
-key:<keystroke file>
When the <keystroke file> is a macro, this switch causes it to execute when NX starts up. To execute a series of macros, list their names in the <keystroke file>, and give the file a ".lxt" extension. When NX starts, the macro files listed in the .lxt file execute sequentially.
Example:
ugii -key:start.macro
2.
-run
Specifies that NX is to run a GRIP program. It prevents an interactive version of NX from displaying. Instead, it runs the GRIP program specified on the command line. The -dir, -dev, and -name options are only valid when used with the -run option. For more details about the Gripbatch command line syntax, see Running a GRIP program in the Open GRIP Help. 作者: 风里密码 时间: 2005-2-22 12:23
呵呵，感谢 楼上 大哥，试一下先作者: gaochongjun 时间: 2005-2-22 14:04
请问楼主，这样有什么实际用途请赐教！！作者: Yeager 时间: 2005-2-26 10:34
舉例一下:
若要求一打開UG,就自動開啟某個樣本檔(Template File),那就必須如此做了!!
1.UG中作個macro,動作為"open xx.prt"=>"進入modeling"
2.以5樓提的方式,啟動UG時同時執行該macro.
