为什么会干涉?

原为0.3mm一刀,因附件要小于512MB,改为1mm一刀,尽示意.
Collision/gouge check summary

Note: Only the tool is checked for collisions and gouges.
      The tool holder is not checked.

Number of operations analyzed:  1
Number of reported collisions:  0
Total reported collision volume:  0.00000
Total collision volume:  0.00000
Number of reported gouges:  11
Total reported gouge volume:  11.94033
Total gouge volume:  80.66720

Gouge/collision points with a volume of at least 0.12629

Gouge:     X441.576 Y134.773 Z-21.158   Volume = 0.88991   Depth = 0.026   Tool #6   ID #12
Gouge:     X456.744 Y559.846 Z-21.158   Volume = 1.01297   Depth = 0.033   Tool #6   ID #12
Gouge:     X160.750 Y575.217 Z-21.158   Volume = 0.83256   Depth = 0.026   Tool #6   ID #12
Gouge:     X456.280 Y559.514 Z-22.157   Volume = 1.94391   Depth = 0.040   Tool #6   ID #12
Gouge:     X161.880 Y574.767 Z-22.157   Volume = 1.37722   Depth = 0.026   Tool #6   ID #12
Gouge:     X455.934 Y559.191 Z-23.155   Volume = 0.22333   Depth = 0.033   Tool #6   ID #12
Gouge:     X195.181 Y311.413 Z-109.983   Volume = 0.94765   Depth = 0.073   Tool #6   ID #12
Gouge:     X436.465 Y139.014 Z-110.981   Volume = 0.38893   Depth = 0.033   Tool #6   ID #12
Gouge:     X195.402 Y310.987 Z-110.981   Volume = 0.17434   Depth = 0.026   Tool #6   ID #12
Gouge:     X205.728 Y570.953 Z-111.979   Volume = 2.36664   Depth = 0.073   Tool #6   ID #12
Gouge:     X452.215 Y555.297 Z-113.975   Volume = 1.78286   Depth = 0.033   Tool #6   ID #12

不好意思,附件太大,又改为2MM一刀
MC8文件见附件

没怎么看懂你想问的意思..

我知道了，他把K说成M了，然后其他意思我还不知道