求助，用ANSYS命令流建歧管三通模型

求助 用ANSYS命令流建歧管三通模型
具体尺寸先不用管。关键是怎么建啊，哪位大侠帮下忙，急用。
我在网上找的T型三通的命令流：
/PREP7  
CYLIND,0.0213/2,0.01576/2,0,0.0594,0,360,
WPSTYLE,,,,,,,,1  
WPAVE,0,0,0.594E-01  
wpro,,,90.000000
CYLIND,0.0334/2,0.02664/2,-0.0715,0.0715,0,360,  
wpstyle,0.05,0.001,-1,0.02,0.003,1,0,,5  
VSBW,1
vsbw,2
wpro,,90
vsbw,1
vsbw,5
vsbw,3
vsbw,4
vdele,1,,,1
vdele,4,9,1,1
wpro,,,90
vsbw,2
vdele,1
vdele,3
aplot,all
WPSTYLE,,,,,,,,0
aovlap,3,21
adele,1,,,1
adele,11,,,1
aovlap,5,24
adele,1,,,1
adele,11,,,1
adele,20,,,1
adele,9,,,1
adele,6,,,1
adele,38,,,1
adele,17,,,1
/VIEW,1,1,1,1
AFILLT,4,12,0.0095,  
al,65,23,32,37,44,4,33
al,45,29,6,43,8,31,26
va,19,1,5,6,2,4,16,3,9,7
命令都能看懂，但我找不到面和体的编号，所以不知道改成建歧管三通该怎么改。
哪位大侠帮忙改下，歧管三通就是把那个支管从垂直方向改成45度方向。命令该怎么改啊。
谢谢了，好人一生平安。