Mastercam Post 换刀前插入行号

taoshx · 发表于 2012-11-6 08:22:34

马上注册，结交更多同行朋友，交流，分享，学习。

您需要登录才可以下载或查看，没有帐号？注册

x

本帖最后由 taoshx 于 2012-11-6 08:24 编辑

包含以下代码，后处理下载地址：https://attao.blog.163.com/blog/static/205398212201210313339485/

strgoto_N : 10                #参数初始化N10
fmt  "N" 4  strgoto_n       #定义strgoto_n数据类型
paddgotoN                      #定义paddgotoN结构类型
   *strgoto_N,e$
   strgoto_N = strgoto_N + 10 #N增量，

#在Psof中插入行号paddgotoN
psof$          #Start of file for non-zero tool number
   ptravel
   pwritbuf5
   pcuttype
   toolchng = one
   if ntools$ = one,
      [
      #skip single tool outputs, stagetool must be on
      #stagetool = m_one
      !next_tool$
      ]
   tooltotal = rbuf(4,0)  #Reads total tool and null tool changes
   if toolcountn <= tooltotal, nexttool = rbuf(4,toolcountn)
   else, nexttool = first_tool$

   if tool_table = 2, ppredstck,e$
   if tool_table = 3, pmetastck,e$
   spaces$=sav_spc
   paddgotoN                #-------插入paddgotoN结构
   if plane$ < 0, plane$ = 0
   pbld, n$, *sgcode, *sgplane, *smetric, "G40", "G49", "G80", *sgabsinc, e$,
   sav_absinc = absinc$
   if wcstype <= one, #Work coordinate system
      [
      absinc$ = one
      pfbld, n$, sgabsinc, "G28", "Z0.", e$
      pfbld, n$, "G28", "X0.", "Y0.", e$
      pfbld, n$, "G92", *xh$, *yh$, *zh$, e$
      absinc$ = sav_absinc
      ]
   sav_mi9 = mi9$
   sav_workofs = workofs$
   if sav_workofs < 0, sav_workofs = 0
   ptlchg_com
   sof = 0

#在ptlchg中插入行号paddgotoN
ptlchg$       #Tool change
   pcuttype
   toolchng = one
   toolcount = toolcount + 1
   if toolcountn <= tooltotal, nexttool = rbuf(4,toolcountn)
   else, nexttool = first_tool$

   if wcstype = one, #Work coordinate system
      [
      pfbld, n$, "G28", "X0.", "Y0.", e$
      pfbld, n$, "G92", *xh$, *yh$, *zh$, e$
      ]
   pbld, n$, *sm01, e$
   paddgotoN                   #-------------插入paddgotoN结构
   pbld, n$, *sgcode, *sgplane, *smetric, "G40", "G49", "G80", *sgabsinc, e$
   if mi10$=one, n$, *sm00, e$
   ptlchg_com