【讨论】UG NX2.0 + MoldWizard NX2.0

changshuo

UG NX2.0 + MoldWizard NX2.0  
  
在UG NX2.0 + MoldWizard NX2.0 里我在用 Create Pockets 给斜顶跟滑块建腔时,发现老是建不了腔,后来我用MoldWizard NX1.0.1G跟UG NX2.0结合后(也就是UG NX2.0 + MoldWizard NX1.0.1)再用 Create Pockets 给斜顶跟滑块建腔却一切OK.   Create Pockets 命令在WM1.0.1版本跟以前的版本用法都一样,然而到WM2.0后, Create Pockets命令完全改了,我按命令提示去做(用Create Pockets 给斜顶跟滑块建腔)竟然不行,大家试一试.
  
What’s New
Create Pockets
What is it?
The Create Pockets dialog has been changed to a selection steps style. In addition, new functionality has been added that displays the target components that intersect a selected standard component.
Why should I use it?
The new dialog provides you with tools to clearly see that the pockets are being created in the correct components.
Where do I find it?
Mold Wizard toolbar-> Create Pockets icon.
  

changshuo

navy-45

songzheng

navy-45

bafngood

alexlinliwei

好莲居士

zealous

小桥流水