标题: 各位大侠帮帮我吧 宏命令出问题 [打印本页] 作者: kurupikt 时间: 2011-9-25 15:14 标题: 各位大侠帮帮我吧 宏命令出问题 各位大侠，我按照一篇论文编辑了在链条铰链处施加铰接副的宏命令如下
variable create variable_name= ip integer_value= 3
while condition= ( ip< 70)
variable modify variable _name= ip integer _value= (eval ( ip+ 2) )
constraint create joint Revolute &
joint _name= (eval ("J _ "// ( ip/2+ 500) ) )&
i_ marker _name= (eval ("_ "// ip ) )&
j_ marker _name= (eval (" _ "// ( i p+ 1) ) )
force create element_ like friction &
friction _name = (eval ("F_ "//( ip//2+ 500) ) ) &
mu _static = 0.12 &
mu _dynamic = 0.1 &
stiction _t ransition _velocity = 2 &
max _stiction _deformation = 0.01 &
effect = all &
preload = on &
reaction _force = on &
bending _moment = on &
friction _arm = 1.0 &
pin _radius = 2.0 &
friction _torque _preload = 0.0 &
inactive _during _static = off
end
但是调试时的部分结果如下：
ERROR: Error detected on line number 3, character 37 of the macro '.MACRO_1'.
ERROR: Invalid input. Enter '='.
ERROR: The command was not executed.
ERROR: +2>> variable modify variable _name= ip integer _value= (eval ( ip+ 2) )
ERROR: Error detected on line number 5, character 18 of the macro '.MACRO_1'.
ERROR: Invalid input. Enter '='.
ERROR: The command was not executed.
ERROR: +2&> joint _name= (eval ("J _ "// ( ip/2+ 500) ) )&
ERROR: Error detected on line number 8, character 33 of the macro '.MACRO_1'.
ERROR: 'like' is not a valid keyword. You may have misspelled
ERROR: the keyword or you may be missing a continuation character(&)
ERROR: on the previous line.
ERROR: The command was not executed.
ERROR: +2>> force create element_ like friction &
请问我应该怎样修改 谢谢了