#=============================================================
proc PB_CMD_init_turbo { } {
#=============================================================
#
# This custom command may only be used with Post Builder 3.2.1
# or later and NX2 or later.
#
# Place this custom command with the "Start of Program" marker.
#
#
# This custom command will activate the turbo process mode for
# the 3-axis mill posts. The execution time will be about 5 to
# 10 times faster than the normal process.
#
# Special Blocks are included in any 3-axis mill post created
# by Post Builder v3.2.1 and on.
#
# The blocks being output are formatted similar to that of the
# Fanuc type of controllers.
#
# The following turbo blocks will appear in the Block section
# of N/C Data Definitions in Post Builder:
#
# linear_move_turbo
# circular_move_turbo
# rapid_move_turbo
# sequence_number_turbo
#
# In Post Builder, you may modify the Word parameters from
# the N/C Data Defitions dialog to configure the output of that
# word used within the turbo blocks. You may also modify the Format
# parameters. You may not, however, edit the expression in the
# words, remove or add words in any turbo block.
#
# All rapid motion is output in a single move. Any custom
# commands in the linear move, circular move, rapid move and
# mom_before_motion event markers will be ignored.
#
