后置处理程式中三轴极限值的呼叫

你的tcl语法好像漏洞百出啊，楼主，改的我好苦啊！！！！！！！！！！！！！

[ 本帖最后由 cqwcd 于 2006-4-11 16:05 编辑 ]

global max_z min_z zmax zmin
global max_x min_x xmax xmin
global max_y min_y ymax ymin
global max_b min_b

set zmax [string trimright [format %.4f $max_z] 0]
set zmin [string trimright [format %.4f $min_z] 0]
set xmax [string trimright [format %.4f $max_x] 0]
set xmin [string trimright [format %.4f $min_x] 0]
set ymax [string trimright [format %.4f $max_y] 0]
set ymin [string trimright [format %.4f $min_y] 0]
set bmax [string trimright [format %.3f $max_b] 0]
set bmin [string trimright [format %.3f $min_b] 0]
  
MOM_output_literal ";(Zmax = $zmax , Zmin = $zmin)"   
MOM_output_literal ";(Xmax= $xmax , Xmin = $xmin)"   
MOM_output_literal ";(Ymax = $ymax , Ymin = $ymin)"
MOM_output_literal ";(Bmax = [format "%.3f" $bmax] , Bmin = [format "%.3f" $bmin])"

请各位看看
以上程序错误在哪里?
谢谢！！！

dddddddddddddddddddddd

顶起来.

好东西！