(做题了)UG中高手门来挑战了..

也是吧!你们搞的是什么我也产是很了解啊!!!!!!!
]

原帖由 秋风红叶 于 2007-3-1 14:25 发表
一步

刚刚发现你这样做对称过去就不、相忉了

原帖由 毛南菜牛 于 2007-3-1 20:59 发表
一步。。。
呵呵。。。
高手中的高手。。。

To upper

Would you mind to tell me that how to sweep this freeform feature using only one step?
i really do not know. whether  it need to create any other assistant curves?
thanks

原帖由 毛南菜牛 于 2007-3-1 21:50 发表


刚刚发现你这样做对称过去就不、相忉了

看来你不会变扫

原帖由 qqricky 于 2007-3-2 08:22 发表
To upper

Would you mind to tell me that how to sweep this freeform feature using only one step?
i really do not know. whether  it need to create any other assistant curves?
thanks

老兄E文不错,
变扫的教程前面已经有的几个贴了.
现有空,灌灌水也无妨

高手啊顶

大力支持秋兄

我日哦　　猴年马月的东西了

Thanks for your kindly answer. I have learned this variational sweep.

But as this subject, i find that your 3D model is different from the one that subject shows.
Something get wrong, pls find them as  the below piture shows.
Another question, how can you do it successfully using one step in modeling application of UGNX2.0 but NX4.0?
i think it may need two or three features to finish it, even more steps, is not it?

thank you!