The Runner to Beams dialog appears.
Identify the simple sections of the runner system. Simple sections are straight or gently curved and have no junctions or sharp corners.
Repeat the following for all simple sections:
Select any node on the section.
Click Apply.
The simple section containing the node is converted into a beam.
When all simple sections have been converted, click the Start Stage 2 checkbox.
Repeat the following for all remaining parts of the runner system (corners and junctions):
Select any node on the section.
Click Apply.
The section containing the node is converted into a beam section.
Click Close to dismiss the dialog. Note: You can specify properties of the runner system (e.g., hot or cold runners) by clicking on ... next to Create as in the dialog.
发表于 2008-12-25 08:20:15
