【讨论】用Mold Adviser 6.0和Part Adviser 6.0这里报名讨论

今天似乎sw没有人气。这个模块我也不熟悉，是注塑分析模块，刚才随便弄了几下出来一个报告，全当关税。给大家看看
MOLDFLOW PLASTICS ADVISERS REPORT  
--------------------------------------------------------------------------------
1Prepared By: lhg  
Prepared for: idesign  
Date: 02-09-2002
  --------------------------------------------------------------------------------
Introduction
--------------------------------------------------------------------------------
Summary
Release Level: 6.0  
  
cover_results-2  
Part Name: cover2  
Material Supplier: DSM  
Material Grade: Stamylan P 16M10  
Max Injection Pressure: 100.00 MPa  
Mold Temperature: 40.00 deg.C  
Melt Temperature: 230.00 deg.C  
Model Suitability: Part model was highly suitable for analysis.  
  
cover_results-2  
Moldability: Your part can be easily filled but part quality may be unacceptable.
  
View the Quality plot and use the Dynamic Adviser to get help on how to improve the quality of the part.  
Confidence: Medium  
Injection Time: 0.36 sec  
Injection Pressure: 26.07 MPa  
Weld Lines: Yes  
Air Traps: Yes  
Shot Volume : 14.51 cu.cm   
Filling Clamp Force: 9.77 tonne  
Packing Clamp Force Estimate @20%: ( 5.21 )MPa 2.89 tonne  
Packing Clamp Force Estimate @80%: ( 20.86 )MPa 11.54 tonne  
Packing Clamp Force Estimate @120%: ( 31.28 )MPa 17.31 tonne  
Clamp Force Area: 54.27 sq.cm  
Cycle Time: 12.00 sec  
Warnings:   
  
cover_results-2  
Cooling Quality: Your part has some small problems and may not cool satisfactorily.  
Temperature Range: -3.93 deg.C to 6.64 deg.C  
Freeze Time Range: -1.17 sec to 2.16 sec  
  
cover_results-2  
Sinkability: 3 % of your model was found to be prone to sink marks.  
  
  

Glass Model:P

Solid Model

Plastic Flow

Fill Time8D8D8D8D

2Confidence of Fill

Injection Pressure

Pressure Drop

Flow Front Temp

Quality Prediction