Notes:Unless otherwise specified
1. See bom for component part numbers and specifications
2. Key characteristics to be monitored as vendor spc points data required nith each shipment
3. Φ0.1262 min gage pin must drop thru both Φ0.1285 holes at the time
4. This dimension applies to smallest Φ of punched holes to breax out (largest diameter) toward interior side . Maximum puncn to die clearance is 0.005 per side (0.010 on diameter)
5. Burrs not to exceed 0.005 in height.
Notes:
1. See bom for component part numbers and specifications
2.  art to be free of visible rust (when viewed from 24°under 40w fluorescent light-distance to light source 36°for 3 seconds)
3. All exterior sharp corners may be R0.015 max
4. This area to be burr-free
5. Key characteristics see detail c
6.  art to be clean, Free of oil, Grease and other contaminations.
发表于 2004-8-2 15:29:48
art to be free of visible rust (when viewed from 24°under 40w fluorescent light-distance to light source 36°for 3 seconds) 
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
收藏
淘帖
赞一下！
楼主