A single cavity off set hot spure gated mold. An incoe manifold system will be required. The cavity an core are to be inserted and are to be a pre-hard P-20.Automatic unscrewing is required for the threads. The 2”threaded these are the 2 threaded ports 2” National Pipe Tapered section is to be inserted on the drive units. Automatic unscrewing is also required for the 2-1/4-18NPSM threads. Hydraulic core pull is required for the side action. The Hayward logo is to be inserted. Good water cooling is required. The mold is to run fully automatic in a 700 ton press at an estimated cycle of 27 SPH. Shots per hour or 133 seconds.
中文大概意思是:直浇口单型腔模具,Incoe热流道系统。型腔和型芯镶件材料为预硬钢P20。螺纹要求可以自动松卸的。驱动部分要加入双头螺纹单元。自动松螺纹装置尺寸要求是2-1/4-18NPSM。机器要求有侧向液压抽芯功能。模具上要加上Hayward商标。冷却系统工作良好。模具可以在700吨和工作周期大约为27模/小时的状况下全自动工作。