求助！UGNX3創建及打開文件出錯問題。(最新附出錯LOG)

只看该作者 · 发表于 2005-9-26 11:00:09

小弟是新手，剛學UG。裝上UGNX3後，
UG NX3.0 启动后创建新部件文件或打開部件（*prt）的时候出现
fatal error detected unable to continue
之后就整个NX程序中断退出
苦思不得其解。懇請各位大俠幫幫忙。不勝感激！！

為了方便大家幫我分析原因，我相信也不止我一個人碰到這樣的問題。希望大家
能夠分析出原因，搞定問題。如果是這樣，這張貼子應該可以置頂。
Loaded and updated part "E:\MyDesign\Demo\prt0004_igs.prt" cpu 0.328, real 2.969
eng6 eng6:0.0 GeForce4 MX 440/AGP/SSE2 configuration:polyline_set=array_set,single,immediate_mode,8:tri_set=array,single,display_list,8:tri_strip_set=array_set,single,immediate_mode,8:
Displayed in: CPU time: 0.046 secs, Real time:  0.656 secs
errno=2
*** ERROR code 11 in line 1893 of d:\ugnx20\sandbox\src\syss\error\ind\error.c at Fri Oct 07 17:34:23 2005 台北標準時間
+++ O/S ERROR: signal 11, code 00000000
Using the following path to locate pdb files:
C:\Program Files\EDS\Unigraphics NX 2.0\UGII;C:\Program Files\EDS\Unigraphics NX 2.0\ugii;C:\WINNT\system32;C:\WINNT;C:\WINNT\System32\Wbem;C:\Program Files\Common Files\Autodesk Shared\;D:\PTC\emx4.0\bin;d:\ptc\pdx2.1\bin;D:\PTC\proeWildfire 2.0\bin;D:\PTC\proeWildfire 3.0 SV\bin;C:\Program Files\EDS\Unigraphics NX 2.0\ugii\
[ 1] 695D5196                                                             (nvoglnt)
>>>> Calling ERROR_longjump to go to "BASE_ask_part_header_info"
set root/work part failed "E:\MyDesign\Demo\prt0004_igs.prt": CPU time: 0.562 secs, Real time:  4.984 secs
>>>> Calling ERROR_longjump to go to "UI_PART_open_part"
>>>> Calling ERROR_longjump to go to "MB_ask_toggle_state_by_name"
>>>> Calling ERROR_longjump to go to "TBRToolbar::OnCommand"

附詳細文件：

[ 本帖最后由 Micowen989 于 2005-10-8 08:24 编辑 ]