PW2.0或PW3.0+EMX再生模架容易跳机

PW2.0或PW3.0+EMX4。1再生模架容易跳机,不知是什么回事,所以不敢用野火来设计模具,郁闷.
还是P2001+EMX稳定，不知各位同行有否这种现象。

[ 本帖最后由 yaoyongyu 于 2006-7-15 17:06 编辑 ]

不会呀，用WILDFIRE2.0用EMX4.0做开模具模拟的时候就会死机。但4.1就不会，WILDFIRE3.0用4.1也没事！

真的不行呀，开好模架时没事，但修改模架尺寸，或者开框，或者在回针上装弹簧，都会出现再生失败或者干脆跳机。闷。
    现在只能在PE2001里做好3D，在野火里标数了。野火标数还是爽的，特别是3。0

你用的EMX是M150的版本吧

他的那个螺钉孔 PTC已经解决了
你到网上去下载有个 M350的版本的EMX
这个和PRO/E 无关
是PTC自己的问题！~~

Installation:

As an extension pack of Pro/E, You should install Pro/ENGINEER WILFRE2.0 or WILDFIRE 3.0 before you install the EMX5.0  F000 extension pack of pro/E and ensure your pro/e license includes the #192 feature< Feature Expert_Moldbase(192)> of pro/e. Of course, prior to rlz lic gen of Pro/e for WILDFIRE2.0 and 3.0 by ZWT includes the feature.

Attention:
   The EMX 5.0 no longer supports lower version of pro/E, the Pro/ENGINEER 2001 and WILFIRE can't run it enven if you have the right lic!

OK, if the above reday, let's go now:

run setup, choose all installation options and the right language which you need and choose an installing location, e.g. c:\ptc\emx5.0 , then Press Next button till finish.


Copy the following file under the installed emx5.0.F000 directory, e.g.:
c:\ptc\emx5.0\text\config.pro
  and paste it into the following installed directory of pro/e:
  e.g. for wildfire 2.0, please paste it into here:
       \proeWildfire 2.0\text
e.g. for wildfire 3.0, please paste it into here:
       \proeWildfire 3.0\text